Cooler Master RC-1010 Manuel d'installation télécharger pdf (Page 56)

03-02

( Factory setting)

Setting Description

Function Number Setting Value

Yes

( Factory setting)

Setting Description

Function Number Setting Value

Yes

1-4. Setting the Auto Restart

Enable or disable automatic system restart after a power outage.

1-5. Setting the Indoor room temperature sensor switching function

(Only for Wired remote controller)

The following settings are needed when use the control by

Wired remote controller temperature sensor.

( Factory setting)

Setting Description Function Number Setting Value

1-6. Setting the Remote controller signal code

Change the indoor unit Signal Code, depending on the remote controllers.

( Factory setting)

Setting Description

Function Number Setting Value

Operation/Stop mode

(Setting forbidden)

Forced stop mode

1-7. Setting the External input control

"Operation/Stop" mode or "Forced stop" mode can be elected.

* If setting value is "00" : Room temperature is controlled by the indoor unit temperature sensor.

* If setting value is "01" : Room temperature is controlled by remote controller unit sensor.

1 2 ... 51 52 53 54 55 56 57 58 59 60

Pas de commentaire

Cooler Master RC-1010 Manuel d'installation Page 56